Accessories

Fully functional demo unit. Only available to Canadian customers. A power supply for current probes, FET probes, and differential probes. Supplies power for up to four probes, including large current probes. (For 702915 and 702916, up to two probes can be powered when measuring maximum current.)

Fully functional demo unit. Only available to Canadian customers. The Yokogawa 720220 -Channel Voltage Input Module, used in the DL850 ScopeCorder, is a multichannel voltage module capable of measuring 16 channels of DC voltage on a single unit. Scan method measurements are possible by using a removable spring terminal block (removable in 8 channel sections) at the input. The input section uses Weidmueller B2L 3.5/16LH clamp connectors. The maximum sampling rates are 200 kS/s (1 CH) and 10 kS/s (16 CH simultaneous). The minimum voltage input range is 200 mV/div, and the maximum is 42 V (direct input, 1 kHz or less).You can build a 128 CH measuring system by installing up to 8 modules in a single DL850. On each of the 16 channels (and subchannels) in the Yokogawa 720220, you can individually set the range and other input conditions, position, zoom, and other display conditions. Input terminal blocks are isolated from ground. There is no isolation between channels within the input terminal block. Specifications of the Yokogawa 720220 include: Input Channels: 16 Input Coupling: DC, GND (Selectable for each sub-CH) Maximum Sample Rate: 200kS/s (single CH) [10kS/s when using 16-CH] Input Type: Isolated unbalanced Frequency Range: (-3dB)*1 DC to 5kHz Voltage-Axis Sensitivity Setting: 200mV/div (1-2-5 steps) Maximum Input Voltage: (1kHz or less) Direct Input - 42V (DC+ACpeak) Maximum Allowable Common Mode Voltage: (1kHz or less) Direct Input 42V (DC+ACpeak) (CAT 1 and CAT II, 30 Vrms) Vertical (voltage) Axis Accuracy: DC Accuracy ±(0.3% of 10div) Input Connector: Spring-type terminal (removable per 8CH) Input Impedance 1MO ±1% Common Mode Rejection: Ratio 86 dB (50/60 Hz) or more (Typ.) A/D Conversion Resolution: 16-bit (2400 LSB/div) Temperature Coefficient: Zero point: ±(0.015% of 10div)/°C (Typ.) Gain: ±(0.01% of 10div)/°C (Typ.) Bandwidth Limit: OFF/500Hz (Selectable for each sub-CH)

Fully functional demo For DSA-815/TG Models Energized by USB; connected with PC for operations and controlled through the program control panel on the PC. Provide 10MHz reference signal output and can easily realize clock synchronization with other devices of the system. Built-in 50MHz signal which can be connected to the input port by “switches” to facilitate users' learning, operation and demonstration of the spectrum analyzer. 500MHz and 1GHz local oscillator signal outputs with good phase noise to convenient users' various measurement needs when there is no signal source. Modular circuit design; provide interfaces for users to make separate measurement of any component; enable to replace any component.